Serv-A-Pure 73000S, Empty Three Filter Housing Assembly, No Filter Included
You are buying a 3 housing whole house water filtration system that you can drop any standard 20" Big Blue Filters into. This system comes ready to run, minus the internal filters.
Standard System Features
- SW-4 plastic housing wrench included
- SW-4 plastic housing wrench included
- Mounting Bracket comes pre-installed
- Inlet/Outlet pressure gauges come installed
- Inlet/Outlet lead free brass ball valves included
- Genuine Pentek 20" Big Blue Filter housings are used
- The flow direction can be user selected. When standing out front of the system, does your water flow from right to left or left to right? Which ever it is, this is the selection you choose when adding the system to your shopping cart. If you are not sure which direction you need, you can change the flow direction when you receive the unit, it will just require you taking off the bracket and pressure gauges, then flipping the flow direction and reinstalling the bracket and gauges.
Technical Specification
- Flow Rate: Will depend on which filter you choose to install in this housing
- Flow Rate: Will depend on which filter you choose to install in this housing
- Pressure Drop: Will depend on which filter you choose to install in this housing
- Max Temperature: 100°F
- Max Pressure: 90 psi
- Max Pressure: 90 psi
- Housing Material: Polypropylene
- O-Ring Material: EPDM
- In/Out Size: 3/4" FNPT
Pressure Gauges
Why include pressure gauges on my system?
- Including pressure gauges on the inlet and outlet of this system allows you to monitor the pressure drop across the filter and is a good tool for trouble shooting any issues you may have with the installed filter. The higher the pressure drop across the two gauges, lets you know the filter is starting to be plugged up and once the pressure drop gets too high, lets you know it is time to change your filter.
• Pressure Gauge #1 - Located at the inlet of the 1st filter housing. Measures incoming pressure to system.
• Pressure Gauge #2 - Located at the outlet of the 1st housing. Measures pressure leaving the system.
Example: To figure out the pressure drop across the system, take the pressure shown on Pressure Gauge #2 and subtract the pressure shown on Pressure Gauge #1. This difference is the pressure drop you are seeing across your filter system. For best results, take these readings with water flowing through the system.
Pressure Gauge Locations
- Pressure Gauge #1 - Located at the inlet of the first filter housing. Measures incoming pressure to system.
- Pressure Gauge #2 - Located at the inlet of the 2nd housing. Measures pressure drop across the 1st filter.
- Pressure Gauge #3 - Located at the inlet of the 3rd housing. Measures pressure drop across the 2nd filter.
- Pressure Gauge #4 - Located at the outlet of the 3rd housing. Measures pressure drop across the 3rd filter.
