Serv-A-Pure 72000S, BBFS-22, No Filters Included
You are buying a 2 housing whole house water filtration system that you can drop any 20" Big Blue Filters into. This system comes ready to run, minus the internal filter.
Pressure Gauge Locations
• Pressure Gauge #1 - Located at the inlet of the 1st filter housing. Measures incoming pressure to system.
• Pressure Gauge #2 - Located at the outlet of the 1st housing. Measures pressure drop across 1st filter.
• Pressure Gauge #3 - Located at the outlet of the 2nd housing. Measures pressure drop across 2nd filter.
It is recommended that your sediment filter be the first filter to come into contact with the water to help remove sediment that will cause premature plugging of the later filters.
Standard System Features
- Comes with a SW-4 plastic housing wrench
- Comes with a SW-4 plastic housing wrench
- Comes with 3 pressure gauges
- 3/4" In/Out brass ball valves
Technical Specification
- Estimated Flow Rate: 5 GPM (This varies depending on which cartridge you choose. Check filter specifications for actual flow rate)
- Max Temperature: 100°F
- Max Pressure: 90 psi
- pH: >7, if below 7, contact Serv-A-Pure for proper application
- Comes with a SW-4 plastic housing wrench
- Estimated Flow Rate: 5 GPM (This varies depending on which cartridge you choose. Check filter specifications for actual flow rate)
- Max Temperature: 100°F
- Max Pressure: 90 psi
- pH: >7, if below 7, contact Serv-A-Pure for proper application
- Comes with a SW-4 plastic housing wrench
